CHAPTER 5 - BRIDGE MEASURING CIRCUIT

BRIDGE MEASURING CIRCUIT

     A bridge circuit is a type of electrical circuit in which two circuit branches (usually in parallel with each other) are "bridged" by a third branch connected between the first two branches at some intermediate point along them. The bridge was originally developed for laboratory measurement purposes and one of the intermediate bridging points is often adjustable when so used. Bridge circuits now find many applications, both linear and non-linear, including in instrumentation, filtering and power conversion.

     The best-known bridge circuit, the Wheatstone bridge, was invented by Samuel Hunter Christie and popularized by Charles Wheatstone, and is used for measuring resistance. It is constructed from four resistors, two of known values R1 and R3 (see diagram), one whose resistance is to be determined Rx, and one which is variable and calibrated R2. Two opposite vertices are connected to a source of electric current, such as a battery, and a galvanometer is connected across the other two vertices. The variable resistor is adjusted until the galvanometer reads zero. It is then known that the ratio between the variable resistor and its neighbor R1 is equal to the ratio between the unknown resistor and its neighbor R3, which enables the value of the unknown resistor to be calculated.

     The Wheatstone bridge has also been generalized to measure impedance in AC circuits, and to measure resistance, inductance, capacitance, and dissipation factor separately. Various arrangements are known as the Wien bridge, Maxwell Bridge and Heaviside bridge. All are based on the same principle, which is to compare the output of two potentiometers sharing a common source.

     The Wheatstone bridge (or resistance bridge) circuit can be used in a number of applications and today, with modern Operational Amplifiers. We also can use the Wheatstone Bridge Circuit to interface various transducers and sensors to these amplifier circuits.

     The Wheatstone Bridge circuit is nothing more than two simple series-parallel arrangements of resistors connected between a voltage supply terminal and ground producing zero voltage difference when the two parallel resistor legs are balanced. A Wheatstone bridge circuit has two input terminals and two output terminals consisting of four resistors configured in a diamond-like arrangement as shown.

     In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity.

     In some motor controllers, a H-bridge is used to control the direction the motor turns.


References:

Young, Hugh D. Just the FACTS101.

http://dbpedia.org/describe/?url=http%3A%2F%2Fdbpedia.org%2Fresource%2FBridge_circuit&graph=http%3A%2F%2Fdbpedia.org 24 April 2014